1. Accueil
  2. Hubble Connected for Motorola app
  3. Diffusion en direct
  4. J'ai déplacé ou changé de routeur et maintenant ma caméra est hors ligne. Que devrais-je faire?

J'ai déplacé ou changé de routeur et maintenant ma caméra est hors ligne. Que devrais-je faire?

Whenever you move the camera to a different location and/or change a router, you need to make a hard reset of your camera and go through setup again to overwrite the previous router password with the new one. 

You can reset your camera following the below steps:

  • Supprimez à nouveau la caméra de la liste des caméras (si elle est répertoriée uniquement).
  • Then start the hard reset of the camera by holding down the ‘Pair’ button.
  • Turn the camera off while holding down the ‘Pair’ button.
  • After 10 seconds turn the camera back on, while still holding down the’ Pair’ button and wait until you hear a beep.
  • Now, wait till the LED starts blinking. This may take up to 20 seconds. 
  • Maintenant, configurez à nouveau votre caméra.

Please note that the steps for the hard reset depend on the camera model that you have. If you are not sure how to hard reset your camera, please check its user guide for the proper steps or contact customer support at support@hubbleconnected.com.

Mind that you may lose footage that’s in your timeline when doing a hard reset. If there is any video or snapshot you want to save, we suggest you do that before resetting the camera.

Mis à jour le mai 26, 2022

Cet article a-t-il été utile?

Articles Liés

Besoin d'assistance?
Vous ne trouvez pas la réponse que vous cherchez? Ne vous inquiétez pas, nous sommes là pour vous aider!
SOUMETTRE UN TICKET