MOST OF HUBBLE CONNECTED FOR MOTOROLA INDOOR CAMERAS (EXCEPT ORBIT AND HALO):
If you haven’t set up your camera as yet:
- Hold down the ‘Pair’ button
- Turn the camera off while holding down the ‘Pair’ button
- After 10 seconds turn the camera back on, while still holding down the ‘Pair’ button
- When you hear a confirmation beep (after around 20 seconds) release the ‘Pair’ button and wait until the LED starts blinking
- Now you can add your camera to your account.
MOST HUBBLE CONNECTED FOR MOTOROLA OUTDOOR CAMERAS:
If you haven’t set up your camera as yet:
- Hold down the ‘Pair’ button
- Unplug the camera while holding down the ‘Pair’ button
- After 10 seconds plug the camera back in, while still holding down the ‘Pair’ button
- After 20 seconds release the ‘Pair’ button and wait until the LED starts blinking
- Now you can add your camera to your account.
ORBIT CAMERA:
If you haven’t set up your Orbit as yet:
- Remove the back cover
- Press the ‘Reset’ button
- Wait a minute for the Orbit to restart. When the LED is flashing, the Orbit is in setup-mode
- Now you can add your Orbit camera to your account.
HALO CAMERA:
If you haven’t set up your Halo as yet:
- Ensure the camera is in Desk mode. If you are using the camera in Dock mode, detach the camera from the pole and plug the charger into the camera
- Slide the ON/OFF switch to OFF
- Press and hold the ‘Pair’ button, then slide the ON/OFF switch to ON.
- When you hear a confirmation beep (after around 20 seconds) release the ‘Pair’ button
- Wait for the camera to complete an internal reset procedure. The LED indicator will turn red and flash slowly when the camera reset is successfully completed
- You can add your camera again.
LUX64/65 CAMERA:
- Press and hold the PAIR button for approximately 20 seconds.
- You will hear a long beep thence release the PAIR button.
- Wait for the camera to complete an internal reset procedure;
- The red LED will begin to flash when the camera is reset successfully;
- You can add your camera.
RESET WHEN THE CAMERA IS ALREADY SET UP
If you already set up your camera mind that you may lose footage that’s in your timeline when doing a hard reset. If there is any video or snapshot you want to save, we suggest you do that before resetting the camera.
Before going through the above-given steps first delete the camera from the camera list:
- iOS: Tap on the gear icon of the camera you want to remove and then tap ‘Remove Camera’
- Android ™: Tap on the gear icon of the camera you want to remove and then tap on the bin icon at the top right corner.
Now start the hard reset following the earlier given steps.